Brake repair in Gresham, OR
All About Automotive provides brake repair in Gresham, OR, including brake pad replacement, rotor service, caliper repair, and brake fluid flushes for all makes and models. Located at 1850 NW Burnside Rd., open Monday through Friday, 8am to 5pm. Call (503) 465-2926.
Full-system brake service
What we service
Your brakes are a system. When one component wears, it can accelerate wear on everything around it. We inspect the full system and tell you exactly what needs attention now and what can wait.
Brake pads
Brake pads are the first line of wear. We measure pad thickness on all four wheels and replace pads before they damage your rotors. We stock pads for most domestic and import vehicles and can source specialty pads for trucks, SUVs, and performance applications.
Rotors
Worn or warped rotors cause vibration and extend your stopping distance. We measure rotor thickness against manufacturer minimums and resurface or replace as needed. Resurfacing is the right call when metal remains; replacement is the right call when it does not.
Calipers
A sticking caliper drags constantly against the rotor, killing fuel economy and overheating the brake system. A leaking caliper is a safety issue. We inspect calipers for even wear, leaks, and proper retraction every time we touch your brakes.
Brake fluid
Brake fluid is hygroscopic: it absorbs moisture over time, which lowers its boiling point and can cause brake fade under heavy use. Most manufacturers recommend a flush every two to three years. We test fluid condition and perform a complete drain-and-fill when it is time.
ABS system
The ABS warning light is your signal that the anti-lock braking system needs attention. We diagnose ABS faults with professional scan tools, identify whether the issue is a wheel speed sensor, module, or hydraulic component, and repair it properly.
Parking brake
A parking brake that will not hold (or one that does not fully release) can leave you stranded or silently wear your rear brakes. We adjust, repair, and test parking brake cables and electronic parking brake actuators.
Know the signs
Signs your brakes need service
Brakes rarely fail without warning. These are the five signs most drivers notice before a problem becomes serious.
- Squealing or squeaking when you brake. Brake pads have built-in wear indicators: thin metal tabs that contact the rotor and squeal when the pad material is nearly gone. This sound is deliberate. It means schedule service this week, not next month.
- Grinding noise when stopping. Grinding means the pads are fully worn and metal is cutting into the rotor face. Every stop damages the rotor further. This requires immediate service.
- Vehicle pulls to one side when braking. Uneven brake wear, a sticking caliper, or a collapsed brake hose can pull the front end left or right under braking. This is unpredictable in an emergency stop.
- Soft, spongy, or low brake pedal. A pedal that travels farther than normal, or that feels soft underfoot, points to air in the brake lines or a fluid leak. Neither gets better on its own.
- Vibration or pulsing through the pedal or steering wheel. Warped rotors create a pulsing feeling every time the high spot on the rotor passes under the pad. Resurfacing or replacing the rotors eliminates it.
If your brake warning light is on, do not wait for a symptom to develop. Schedule a brake inspection or call us at (503) 465-2926.
Common questions
Brake repair FAQ
How much does brake repair cost in Gresham, OR?
Brake repair cost depends on what your vehicle needs. Brake pad replacement typically runs $150–$300 per axle, while rotor resurfacing or replacement adds to that figure. Caliper replacement and brake fluid flushes are priced separately. We give you a written estimate before any work begins. No surprises.
How do I know if my brakes need to be replaced?
The clearest signs are squealing or grinding when you brake, a soft or spongy pedal, the vehicle pulling to one side, or vibration through the steering wheel when you slow down. If your brake warning light is on, have the system inspected right away. When in doubt, a quick brake inspection costs nothing. Call us and we will fit you in.
How long does brake pad replacement take?
A standard brake pad replacement on one axle takes about 45 minutes to an hour. If we are doing both axles, or if the rotors also need attention, plan for one and a half to two hours. We will let you know the timeline when you drop off your vehicle so you can plan your day.
Is it safe to drive with grinding brakes?
No. Grinding means metal is contacting metal. The pads are worn through and the rotors are being damaged with every stop. Stopping distances increase and brake failure becomes a real risk. Do not wait. If your brakes are grinding, call us or drive directly to the shop. We will make time for you.
Related services
Other services at All About Automotive
Brakes are often paired with routine maintenance. While your vehicle is in, we can handle these services in the same visit.